Is Air Rush waterproof?
Air Rush is not IPX rated or waterproof due to the ventilation holes required for air flow
Trek Air Rush FAQ
Air Rush is not IPX rated or waterproof due to the ventilation holes required for air flow
133g / 4.7oz
Presta and Schrader
2*500mAh (7.4V / 3.7Wh)
Battery life depends on tire size and usage.
Less than 1 hours to fully charge from drained.
Air Rush has a built-in display with a segmented and color-coded battery gauge.
Four white bars = 100 - 76%
Three white bars = 75 - 51%
Two amber bars = 50 - 26%
One red bar = 25 - 6%
One blinking red bar = 5% or less
The displayed battery level may be lower than the actual immediately after use. Cycle the power off for one minute and then on for the most accurate state of charge.
Yes.
Turn the unit on and use the "+" and "-" buttons to change target pressure.
Turn the unit on and press and hold play/pause along with the "+" button.
PSI, BAR, and kPa.
Air Rush does not connect to external devices.
Press and hold the Play / Pause button.
To perform a factory reset on Air Rush, press and hold the "-" and "+" buttons for 3 seconds. The display will change to show current firmware and the light will turn on. Release the buttons to reset Air Rush.
14°F to 113°F / -10° to 45°C
Yes, Air Rush will read pressure as soon as the pump is securely connected to the tire valve.
The hose attachment is for easier valve access through spokes and the hose must be used to prevent heat damage to plastic valve stems used on TPU tubes.
80mm x 46mm x 36mm
Bar in .05 increments up to 8.25
KPA in whole (1) increment up to 827
PSI in whole (1) increments up to 120
2 – 120 PSI (0.14 – 8.27 Bar, 13.8 – 827.4 kpa)
The Schrader valve adapter, Presta valve adapter, and hose are available for purchase. A replacement battery will also be available in some regions.
Yes. You can inflate tubeless tires with Air Rush, but you may need a larger pump to seat a tubeless tire.