There are two different modes of connection. When a computer has been inactive for five minutes it drops into standby (power saving) mode. This saves battery life while allowing the computer to be 'On Demand' and start quicker when you start to ride again. When the computer has been inactive for ...
This may be caused by a low/dead battery or interference from other digital devices in the vicinity. Some troubleshooting procedures include:1. Make sure you are away from other digital computers and sensors. 2. Remove the battery from the sensor, wait five seconds, replace the battery and try t ...
Digital signals are greatly affected by metal and the human body (which is mainly water), which can block the signal from the sensor to the computer. If the signal is blocked during the ride the computer will receive a mixed data packet and display a zero until an uncorrupted data packet is rece ...
